Overview

In this section we will have a look at the Qblox instruments and their IO and shortly explain what they are for.

Pulsar

The Pulsar modules are compact qubit control and readout modules (QCM / QRM). They are conveniently controlled over Ethernet and are easily connected to your setup using SMA and SMP connectors. They are also easily combined with other Qblox instruments using Qblox’s SYNQ technology.

Front

Front view of a pulsar.

On the front of a Pulsar module you will find the following components:

  • 4 x SMA male connectors: 4 output for a Pulsar QCM (O[1-4]: 5 Vpp @ 50 Ω) ; or 2 outputs and 2 input channels for a Pulsar QRM (O[1-2]: 1 Vpp @ 50 Ω, I[1-2]: 2 Vpp @ 50 Ω).

  • 4 x SMP female connectors: Marker output channels (0-3.3 V TTL).

  • 6 x status LEDs: See section Frontpanel LEDs.

Back

Back view of a pulsar.

On the back of a Pulsar module you will find the following components:

  • Power: 12 V DC power supply input.

  • RJ45: Host PC connection.

  • 3 x USB:

    • UART/JTAG: For debug purposes only.

    • 2 x SYNQ: For synchronizing multiple Qblox instruments.

  • 3 x SMA:

    • REFin: External 10MHz reference clock input (1 Vpp nominal @ 50 Ω).

    • REFout: 10MHz reference clock output (0-3.3 V @ 50 Ω).

    • TRIGin: External trigger input (0-3.3 V, high-Z).

SPI Rack

The SPI Rack is a modular system for DC current and DC voltage source modules. Modules are designed to maximize output stability. Together with our Galvanically isolated Control Interface and Isolated power supply ground loops are avoided and interference (like 50 Hz) is minimized.

An SPI Rack with a C1b galvanically isolated controller and D5a voltage sources.

S4g 4 channel current source

An S4g current module.

On the front of each S4g module you find:

  • 4 x SMA: DC current source with software-selectable range: ±50 mA, ±25 mA, +50 mA, 18 bit resolution.

  • 4 x MCX: Voltage monitor for each channel.

Technical specifications S4g

D5a 16 channel DAC

An D5a voltage module.

On the front of each D5a module you find:

  • 16 x MCX: DC voltage source with software-selectable range (±4, ±2, +4 V, extendable to ±8 V), 18 bit resolution, 550 Ohm output impedance.

  • 1 x switch: Switch to ramp all outputs down to zero volt.

Technical specifications D5a